Árajánlatkérő kosár

Jelenleg az árajánlatkérő kosara üres

Termékek

TT tengelyszorító acél furatméret 17-35 mm

Material: Steel. For fixing a hub (e.g. drive wheel, rotor or similar) on a shaft. For high torques. Self-centering. Axial offset during mounting (can be compensated by correct positioning). Tolerances, Surfaces Ř-tolerance for shafts and hubs: +/- 0.08mm. Mounting It is essential to degrease the shaft and hub. Install clamping sets nearly completely degreased. Tighten them with a torque wrench to the torque values as per the table.
Azonosító Rajz letöltése D [mm] A[mm] B[mm] d[mm] L[mm] Surface Pressure Hub[N/mm˛] Tightening Torque TA[Nm] Transmissible Axial Force Fax[kN] Transmissible Torque T[Nm] Weight[g] Wrench Width SW[mm]
61550117 CAD 32 22 6 17 30 92 110 25 208 119 30
61550118 CAD 32 22 6 18 30 92 110 25 221 114 30
61550119 CAD 32 22 6 19 30 92 110 25 233 109 30
61550120 CAD 35 24 7 20 33 94 150 30 298 144 32
61550122 CAD 35 24 7 22 33 94 150 30 328 132 32
61550124 CAD 38 25 8 24 35 93 185 33 398 166 36
61550125 CAD 38 25 8 25 35 93 185 33 415 159 36
61550128 CAD 45 29 11 28 41 73 300 36 505 293 46
61550130 CAD 45 29 11 30 41 73 300 36 541 272 46
61550132 CAD 50 30 12 32 44 65 265 37 590 377 50
61550135 CAD 50 30 12 35 44 65 265 37 645 340 50